8. Back Panel Interface
An overview of the back panel interface is provided in section 4.2. This chapter describes each cluster of
connections as shown in Figure 8.1.
1
SPEAKER OUTPUTS
CH 1
CH 2
Ser. N:o
Removed!
SPEAKER OUTPUTS
1+/- CH 1+/-
CLASS 3
2+/- CH 2+/-
1+:+
1+/- CH 1+/-
3+/- CH 3+/-
WIRING
BRIDGE CH 1 & 2:
2- : -
2+/- CH 2+/-
4+/- CH 4+/-
Figure 8.1: Back Panel Interface
8.1. Speaker Outputs
The PLM+ is available with either 4 mm binding posts or Neutrik speakON connectors for the outputs.
The outputs of the PLM+ can produce a high voltage. Do not connect or disconnect loudspeaker/s while the
PLM+ is powered on. Never operate the PLM+ with any portion of bare loudspeaker wire exposed.
For speakON connector versions, do not use mating plugs without the rear covers in place.
8.1.1. Bridge Mode
Power outputs may be bridged on all PLM+ models by following the configuration instructions in the Lake
Controller Operation Manual (I/O CONFIG > OUTPUT CONFIGURATION) and the wiring instructions in this chapter.
Bridge Mode can only be activated/deactivated using the Lake Controller software.
Note: When Bridge Mode is activated, CLASS 3 wiring is required.
3
INPUT 1
INPUT 2
INPUT 3
CH 3
CH 4
PIN 1: SCRN 2: POS 3: NEG
I
F
ANALOG WITH
SO-
LOAT
TM
CLASS 3 WIRING
INPUT 1
INPUT 2
INPUT 3
2
PIN 1: SCRN 2: POS 3: NEG
I
F
ANALOG WITH
SO-
LOAT
TM
1+/- CH 3+/-
2+/- CH 4+/-
BRIDGE CH 3 & 4: 1+ : +, 2- : -
4
5
INPUT 4
INPUT 1-2
INPUT 3-4
1Gbps
PRIM
ACT
1Gbps
SEC
LINK
AES/EBU
SWITCHED 00/ 000 Base-TX
1
1
1Gbps
PRIM
ACT
1Gbps
SEC
INPUT 4
INPUT 1-2
INPUT 3-4
LINK
AES/EBU
SWITCHED 00/ 000 Base-TX
1
1
PLM+ SERIES Operation Manual rev 1.0.0
8. Back Panel Interface
6
ACT
100-240V
2400-2950W
50-60Hz
LINK
PLM 2K44
1
Made in Sweden
Must be grounded/earthed
ACT
100-240V
2400-2950W
50-60Hz
LINK
PLM 2K44
1
Made in Sweden
Must be grounded/earthed
57