Technical Specifications - Lab.gruppen PLM series Operation Manual

Technical Specifications

11. Technical Specifications
S cifi cat ons PLM Series
Model
Number of input channels
Number of output channels
Peak total output all channels driven
Max. Peak output voltage per channel
Max. output current per channel
Max. Output Power
16 ohms per ch. (all ch.'s driven)
8 ohms per ch. (all ch.'s driven)
4 ohms per ch. (all ch.'s driven)
2 ohms per ch. (all ch.'s driven)
16 ohms (channels 1 and 2, while channels 3 and 4 are driven at -3 dB
8 ohms (channels 1 and 2, while channels 3 and 4 are driven at -3 dB
4 ohms (channels 1 and 2, while channels 3 and 4 are driven at -3 dB
2 ohms (channels 1 and 2, while channels 3 and 4 are driven at -3 dB
All channels driven into optimal impedance interval
Audio Performance
THD + N 20 Hz - 20 kHz for 1 W
THD + N at 1 kHz and 1 dB below clipping
Dynamic range with digital inputs (for all supported sample rates)
Dynamic range with analog inputs
Frequency response (1 W into 8 ohms, 20 Hz - 20 kHz)
Common Mode Rejection (CMR)
Internal sample rate
Internal data path
Product propagation delay, best case (96 kHz AES)
Product propagation delay, analog input
Sample Rate Converters
THD + Noise
Analog to Digital inputs
Inputs
Input sensitivity settings
THD + Noise
AES / EBU inputs
Inputs
Supported resolutions
Supported sample rates
Dante Audio Network
Inputs and outputs
Supported sample rates
Supports redundant paths
Flexible topology
Network latency
Device presets
Local memory locations for the settings of the product
Limiters
Adjustable Inter-Sample Voltage Peak Limiter (ISVPL)
Current Peak Limiter < 300 ms
Current Average Limiter (CAL) > 300 ms
LimiterMax (rms and peak limiters)
– MaxRMS (rms voltage limiter)
– MaxPeak (peak voltage limiter)
Gain
Amplifi er gain
Output attenuator
Rear-panel interface
AES / EBU / I/O (input + link)
Analog, 2-channel I/O (input + link)
Output connectors
Auto 10/100, Auto Uplink
Control and monitoring interface
Detachable mains cord
Cooling
Front-panel user interface
Display
Fault/Warning/Limit/Clip indicators
Mute and soft function buttons
Standby Power button
Mute Enable button
Meter button
Menu button
Rotary Encoder
Exit button
Power
Operating voltage (45 - 66 Hz)
Soft start / Inrush Current Draw
Power Average Limiter (PAL)
Power Factor Correction (PFC)
Breaker Emulation Limiter (BEL), software controlled 5 - 32 A
Under-Voltage Limiter (UVL)
Dimensions
Rack rail to rear panel
Overall depth including handles and rear support
Weight
Finish
Approvals
Note 1): Asymmetrically loading the output channels (as shown, for example): If one channel has reduced output power requirements, the voltage drop from the power supply will be reduced,
resulting in a higher voltage and power output for the other channel.
Note 2): Separate 230 V or 115 V versions available. Not selectable on the product.
All specifications are subject to change without notice.
92
PLM Series Operation Manual rev 1.1.9
PLM 20000Q
2
4
20000 W
194 V
67 A peak
1150 W
2300 W
4400 W
4800 W
) 1150 W
1)
) 2300 W
1)
4500 W
1) )
) 5000 W
1)
> 5000 W into 2.2 - 3.3 ohms
<0.05%
<0.04%
>116 dB
>114 dB
+ /-0.05 dB
>74 dB, 20 Hz to 20 kHz
96 kHz
32 bit fl oating point
1.61 ms
1.68 ms
0.00003 %, 20 Hz - 20 kHz, unweighted
2 inputs x 2 link
+12 or +26 dBu
0.00022 %, typical at 1 kHz unweighted at +26 dBu headroom setting
0.00033 %, typical at 20 Hz and 20 kHz unweighted at +26 dBu headroom setting
2 inputs x 2 link
≤ 24 bit
44.1, 48, 88.2, 96, 176.4, 192 kHz
2 inputs, 2 outputs
48, 96 kHz
Yes
Yes
0.8, 1.3 and 4 ms
100
17.8 - 194 V, step size 0.1 V
67 A peak
33 Arms
Yes
Yes
22 - 44 dB, step size 0.1 dB
-Inf to 0 dB, step size 0.25 dB
2 x 3-pin XLR
4 x 3-pin XLR, electronically balanced
Neutrik speakON (1 x NLT8 2 x NLT4)
or 4 Binding Posts (pairs)
2 x RJ45 etherCON
Via Ethernet for Lake Controller software, or DLM (the 3rd Party Protocol)
Neutrik powerCON 32 A
Three fans front-to-rear airflow,
temperature controlled speed
2.5 inch, daylight readable LCD
RGB LEDs and detailed fault description on display
8 provided
On/Standby
Enables muting of outputs and inputs via soft-button keypad
Toggles through meter views
Provides a menu driven interface for full function front panel control
Yes
Provides a "back" function
Universal power supply 70 - 265 V
Yes / max. 8 A
Yes
Yes
Yes, selectable breaker profi le
Yes
W: 483 mm (19"), H:88 mm (2 U),
D: 424 mm (16.7")
498 mm (19.6")
17 kg (37 lbs.)
Black painted steel chassis with black painted steel / aluminum front
CE, ANSI/UL 60065 (ETL), CSA C22.2 NO. 60065, FCC
PLM 14000 PLM 10000Q
2 2
2 4
14000 W 10800 W
193 V 153 V
90 A peak 49 A peak
1150 W 660 W
2300 W 1300 W
4300 W 2300 W
7000 W 2350 W
1150 W 660 W
2300 W 1300 W
4400 W 2400 W
7500 W 2350 W
> 7000 W into 1.8 - 2.1 ohms > 2700 W into 2.4 - 3.2 ohms
>114 dB >116 dB
>112 dB >116 dB
17.8 - 193 V, step size 0.1 V 17.8 - 153 V, step size 0.1 V
90 A peak 49 A peak
44 Arms 25 Arms
Neutrik speakON (2 x NLT4) Neutrik speakON (1 x NLT8 2 x NLT4)
or 4 Binding Posts (pairs) or 4 Binding Posts (pairs)
Two fans front-to-rear airflow, Two fans front-to-rear airflow,
temperature controlled speed temperature controlled speed
140-265 V / 70-135 V 140-265 V / 70-135 V
2)
Yes / max. 5 A Yes / max. 5 A
Yes Yes
No No
No No
No No
W: 483 mm (19"), H: 88 mm (2 U), W: 483 mm (19"), H:88 mm (2 U),
D: 386 mm (15.2") D: 386 mm (15.2")
460 mm (18.1") 460 mm (18.1")
13.5 kg (30 lbs.) 13.5 kg (30 lbs.)
2)