3.5-Inch Drive With 5.25-Inch Drive Adapter - Compaq AP200 Maintenance And Service Manual

3-12 Removal and Replacement Procedures
IMPORTANT: When installing a second Ultra ATA hard drive on the primary controller, you
must use an 80-conductor Ultra ATA cable for optimal performance. This cable is included in
the hard drive option kit.

3.5-Inch Drive with 5.25-Inch Drive Adapter

If you are installing a second 3.5-inch diskette drive into bays 1 or 2 for the first time, you must
use a special adapter bracket. (See Chapter 1 for the spares part number.)
If you are installing a 3.5-inch diskette drive into bay 3, you must use a special adapter bracket.
(See Chapter 1 for the spares part number.)
To remove a 3.5-inch drive with a 5.25-inch drive adapter:
1. Perform the steps in the "Service Preparations" section as previously shown.
2. Remove the access panel.
3. Remove the front bezel.
4. Disconnect the cables from the back of the drive.
5. Press the drivelock to unlock the drive.
Figure 3-13. Releasing the hard drive with the drivelock
CAUTION: Before removing the access panel, ensure that the workstation is
turned off, all cables are disconnected from the back of the workstation, and the
power cord is disconnected from the grounded AC outlet.