3-4
Removal and Replacement Procedures
Access Panel
To remove the workstation access panel:
1.
Perform the steps in the "Service Preparations" section as previously shown.
2.
Remove the two thumbscrews that secure the access panel to the workstation chassis.
3.
Slide the access panel back about 1 inch (2.5 cm), then lift it off the workstation.
Figure 3-4. Removing the access panel
To replace the access panel, reverse the above procedure.
CAUTION: Before removing the access panel, ensure that the workstation is
turned off, all cables are disconnected from the back of the workstation, and the
power cord is disconnected from the grounded AC outlet.