Removing A 3.5-Inch Hard Drive With 5.25-Inch Drive Adapter; Figure 3-10. Removing A 3.5-Inch Hard Drive - Compaq Deskpro Workstation AP250 Maintenance And Service Manual

3-12 Compaq Deskpro Workstation AP250 Maintenance and Service Guide
Removing a 3.5-inch Hard Drive with 5.25-inch
Drive Adapter
Writer: Bruce Sullivan Project: Compaq Deskpro Workstation AP250 Maintenance and Service Guide Comments:
Part Number: 118133-001 File Name: d-ch3 Removal and Replacement Procedures.doc Last Saved On: 10/26/99 3:02 PM
8. While holding the drive casing, pull the drives out of the drive bay 1.

Figure 3-10. Removing a 3.5-inch hard drive

9. Remove the two guide screws from each side of the drive 2.
To replace the 3.5-inch hard drive:
1. Install two 6-32 guide screws on each side of the replacement drive,
making sure the guide screws line up with the guide slots.
2. Slide the hard drive into the drive bay until it locks into place.
IMPORTANT: When installing a second Ultra ATA hard drive on the primary controller,
use an 80-conductor IDE Ultra ATA cable for optimal performance. This cable is included
in the hard drive option kit.
If you are installing a second 3.5-inch diskette drive into bay 1 or 2 for the first
time, you must use a special adapter bracket. (See Chapter 1 for the spare part
number.)
If you are installing a 3.5-inch diskette drive into bay 3, you must use a special
adapter bracket. (See Chapter 1 for the spare part number.)
Compaq Confidential – Need to Know Required
1
2
2