Installing A 3.5-Inch Drive Into A 5.25-Inch Drive Bay - Compaq 239158-999 - Mini Tower - Power Supply 250 Watt Hardware Reference Manual

Hardware Upgrades

Installing a 3.5-Inch Drive into a 5.25-Inch Drive Bay

2-16
5. Connect the drive power
ROM or DVD-ROM drive and if analog audio is preferred to digital
audio, connect the audio cable
3
should be connected to the embedded audio connector on the
system board.
Connecting the Drive Cables
6. Remove the appropriate bezel blank from the subpanel inside the
front bezel. See the section "Removing Bezel Blanks" for more
information.
7. Replace the computer access panel.
8. Reconfigure the computer, if necessary. See the section
"Installation Sequence" for more information.
1. If you have locked the Smart Cover Lock, use Computer Setup
to unlock the lock.
2. Shut down the operating system properly, then turn off the
computer and any external drives, disconnect the power cord
from the power outlet, and remove the computer access panel.
3. Remove the front bezel.
4. Install one guide screw on the right side of the drive.
1 2
and signal cables and, if it is a CD-
3
. The other end of the audio cable
Hardware Reference Guide