Init Display First; Onchip Ide Device; Ide Hdd Block Mode - Albatron PX915P4C Series User Manual

PX915P4C/ PX915G4C Series

Init Display First

With systems that have multiple video cards, this option determines whether the primary display uses
a PCI slot or an AGP slot. Options: PCIEx (default)、PCI Slot

OnChip IDE Device

IDE HDD Block Mode

Block mode is otherwise known as block transfer, multiple commands, or multiple sector read/write.
Select the "Enabled" option if your IDE hard drive supports block mode (most new drives do). The
system will automatically determine the optimal number of blocks to read and write per sector.
Options: Enabled (default)、Disabled
On-Chip channel0/channel1 PCI IDE
The mainboard chipset contains a PCI IDE interface with support for two IDE channels. These two IDE
channels are for IDE1 and SATA1/2/3/4 connectors use. Select "Enabled" to activate the first and/or
second IDE interface. Select "Disabled" to deactivate the interface if you are going to install a primary
and/or secondary add-in IDE interface. Options: Enabled (default)、Disabled
IDE channel0/ channel1/Master/Slave PIO
The IDE PIO (Programmed Input / Output) fields let you set a PIO mode (0-4) for each of the IDE devices
that the onboard IDE interface supports. Modes 0 to 4 will increase performance incrementally. In Auto
mode, the system automatically determines the best mode for each device. Options: Auto (default)、
Mode0、Mode1、Mode2、Mode3、Mode4.
IDE channel0 /channel1 /Master / Slave UDMA
Ultra DMA 100 functionality can be implemented if it is supported by the IDE hard drives in your system.
As well, your operating environment requires a DMA driver (Windows 95 OSR2 or a third party IDE bus
master driver). If your hard drive and your system software both support Ultra DMA 100, select "Auto"
to enable BIOS support.
Options: Auto (default)、Disabled
***OnChip Serial ATA Setting***
On-Chip Serial ATA
This field allows you to select the on-chip Serial ATA operating mode which will determine how you
will use your Serial ATA drives with the other standard IDE drives. This system can physically attach 2
IDE drives and 4 SATA drives but will have certain limitations as described below.
Options：
32