Ide Hdd Block Mode; Usb Controller; Usb Keyboard Support; Init Display First - Albatron PX845PEV-800 Hardware User Manual

IDE HDD Block Mode

Block mode is otherwise known as block transfer, multiple commands, or multiple sector
read/write. Select the "Enabled" option if your IDE hard drive supports block mode (most new
drives do). The system will automatically determine the optimal number of blocks to read and
write per sector. Options: Enabled (default), Disabled.
INTEL OnChip PCI Device
If you highlight the "INTEL OnChip PCI Device" label and then press the enter key, it will
take you a submenu with the following options:

USB Controller

This option should be enabled if your system has a USB port installed on the system board.
You will need to disable this feature if you add a higher performance controller. Options:
Enabled (default), Disabled.
USB 2.0 Controller
This option should be enabled if your system has a USB 2.0 device installed on the system
board. You will need to disable this feature if you install a USB 1.1 device. Options: Enabled
(default), Disabled.

USB Keyboard Support

Enables support for USB attached keyboards. Options: Disabled (default), Enabled.
Onboard LAN Device
This option allows you to control the onboard LAN Device. Options: Enabled (default),
Disabled.

Init Display First

With systems that have multiple video cards, this option determines whether the primary
display uses a PCI slot or an AGP slot. Options: AGP (default), PCI Slot.
Onboard I/O Chip Setup
If you highlight the "Onboard I/O Chip Setup" label and then press the enter key, it will take
you to a submenu with the following options:
PWRON After PWR-Fail
This field will determine whether your system will boot after restoring power after a power
failure. If you select "On", the system will boot whether or not the system was on before power
failure. If you select "Former-Sts", the system will be restored to the status before the power
failure. Options: Off (default),On, Former-Sts.

Power On Function

This option allows you to select a way to power on your computer.
Options: Password, Hot KEY, Mouse Left, Mouse Right, Any KEY, BUTTON ONLY
(default), and Keyboard 98.
KB Power On Password
Supply a password that your system will use as part of the power-on sequence.
Hot Key Power ON
This option allows you to use the Ctrl key along with a hot key (function key) to power on
your system. Options: Ctrl-F1, Ctrl-F2, ..., Ctrl-F12.
Albatron Anniversary Special Edition PX845PEV-800
32