Audio Connectors - Albatron PX915P4C Series User Manual

Jumper: JP1
The "Clear CMOS" jumper allows you to reset your CMOS configurations. This is particularly useful
when you have forgotten your system password and cannot boot to the operating system.
The following steps explain how to reset your CMOS configurations when you
have forgotten your system password.
1. Turn off your system and disconnect the AC power cable.
2. Set JP1 to OFF (2-3 Closed).
3. Wait several seconds.
4. Set JP1 to ON (1-2 closed).
5. Connect the AC power cable and turn on your system.
6. Reset your new password.
Front USB Headers (Yellow): USB1/ USB2
These mainboards provide 2 USB headers on the board allowing for 4 additional USB ports. To make use
of these headers, you must attach a USB bracket/cable with USB ports (some models will come
packaged with a USB 4-port bracket-cable). The optionally packaged bracket will have two connectors
that you can connect to the headers (USB1, USB2). The other end (bracket containing the USB ports) is
attached to the computer casing.
.
If you are using a USB 2.0 device with Windows 2000/XP, you will need to install
the USB 2.0 driver from the Microsoft
Au
later) for Windows
will not have to install the driver.
PX915P4C/ PX915G4C Series
®
website. If you are using Service pack 1 (or
® XP, and using Service pack4 (or later) for Windows® 2000,you
17