Ide Hdd Block Mode; Usb Controller; Usb Keyboard Support; Init Display First - Albatron PX845EV1 Series User Manual

IDE HDD Block Mode

Block mode is otherwise known as block transfer, multiple commands, or multiple sector
read/write. Select the "Enabled" option if your IDE hard drive supports block mode (most
new drives do). The system will automatically determine the optimal number of blocks to
read and write per sector. Options: Enabled (default)、Disabled
INTEL OnChip PCI Device

USB Controller

This option should be enabled if your system has a USB port installed on the system board.
You will need to disable this feature if you add a higher performance controller.
Options: Enabled (default)、Disabled
USB 2.0 Controller
This option should be enabled if your system has a USB 2.0 device installed on the system
board. You will need to disable this feature if you install a USB 1.1 device.
Options: Enabled (default)、Disabled

USB Keyboard Support

Enables support for USB attached keyboards. Options: Disabled (default)、Enabled
AC'97 Audio
This option allows you to control the onboard AC'97 audio.
Options: Auto (default)、Disabled
Onboard LAN Device
This option allows you to control the onboard LAN Device.
Options: Enabled (default)、Disabled

Init Display First

With systems that have multiple video cards, this option determines whether the primary
display uses a PCI slot or an AGP slot. Options: Onboard/AGP (default)、PCI Slot
Onboard I/O Chip Setup
PWRON After PWR-Fail
This field will determine whether your system will boot after restoring power after a power
failure. If you select "On", the system will boot whether or not the system was on before
power failure. If you select "Former-Sts", the system will be restored to the status before the
power failure. Options: Off (default)、On、Former-Sts
PX845EV1/ PX845EV1 PRO
37