Init Display First; Power On Function; Onboard Fdc Controller; Onboard Serial Port 1 - Albatron PX845GEV Series User Manual

Onboard LAN Device
This option allows you to control the onboard LAN Device.
Options: Enabled (default)、Disabled

Init Display First

With systems that have multiple video cards, this option determines whether the primary
display uses a PCI slot or an AGP slot.
Options: Onboard/AGP (default)、PIC Slot
Onboard I/O Chip Setup
If you highlight the "Onboard I/O Chip Setup" label and then press the enter key, it will take
you to a submenu with the following options:
PWRON After PWR-Fail
Set if restart the system after power fail. Choose On, the system will start whether the
system was on before power failed. Choose Former-Sts, the system will restore to the status
before the power failed.
Options: Off (default)、On、Former-Sts

Power On Function

This option allows you to select a way to power on your computer.
Options: Password、Hot KEY、Mouse Left、Mouse Right、Any KEY、BUTTON ONLY
(default), and Keyboard 98
KB Power On Password
Supply a password that your system will use as part of the power-on sequence.
Hot Key Power ON
This option allows you to use the Ctrl key along with a hot key (function key) to power on
your system.
Options: Ctrl-F1, Ctrl-F2...... Ctrl-F12

Onboard FDC Controller

Select "Enabled" if your system has a floppy disk controller (FDC) installed on the system
board and you wish to use it. If you install an add-in FDC or the system has no floppy drive,
select "Disabled" .
Options: Enabled (default)、Disabled

Onboard Serial Port 1

Select an address and corresponding interrupt for the first serial port.
Options: Disabled、 3F8/IRQ4 (default)、 2F8/IRQ3、 3E8/IRQ4、 2E8/IRQ3、 Auto
PX845PEV/ GEV Series
40