Table of Contents
Advertisement
(1) Mail Server
Enter the SMTP Server and port. If your e-mail system requires user identification, enable
Authentication check box and enter ID and Password.
(2) Mail
Fill the mailing information.
From: Enter the sender e-mail address.
To and CC: Enter the recipient email address and separate it with comma or a semicolon
(;).
Subject: Enter the message title.
Message: Type the message.
(3) Snapshot
To take a snapshot when sends out the alarm mail with it.
Select Camera: Select the camera from drop down list to specify which camera video to
be snapshot when the alarm is triggered.
Video Size: Select the size of video for snapshot.
-
Start Recording
Record the video from the selected camera.
1. Beside the Start Recording check box, click Detail.
2. In the Alarm Recording Setting dialog box, select
the camera to enable/disable video recording.
Enable All to select all cameras.
3. In the Frame Rate selection, select As Setting to
record the number of frames based on the
Recording Setting.
4. In the Start Record prior text box, mark and set the
number in second for the program to begin
recording after the alarm has been trigger. The time range is 1~10 seconds.
5. In the Stop Record after text box, mark and set the number in second for the program to
continue recording after the alarm has ended. The time range is 1~999 seconds. If user
doesn't mark and set the time, the alarm recording will continue recording until alarm is
reset.
6. Click OK to accept the new settings and Cancel to exit without saving.
- PTZ preset point
Position the PTZ camera based on the preset point setting.
Beside the PTZ preset point check box, click Detail. In the
Trigger PTZ Preset Setting dialog box, select the PTZ
camera number then select the Enable check box. Select
the position of the PTZ camera when the alarm is activated
and ended. For the PTZ camera end point, user can also
select on preset position or Auto Pan between preset
position groups.
36
Advertisement
Table of Contents
