Using Cbarge; Using Meet-Me - Cisco 7906G User Giude

If you want to...
Join together two existing
conferences
See a list of participants or
remove participants

Using cBarge

You can create a conference by using cBarge to add yourself to a call on a shared line.
If you want to...
Create a conference by
barging a call on a shared line
See a list of participants or
remove participants

Using Meet-Me

Meet-Me conferencing allows you to start or join a conference by calling the conference number.
If you want to...
Start a Meet-Me conference 1. Obtain a Meet-Me phone number from your system administrator.
Join a Meet-Me conference
End a Meet-Me conference
Cisco Unified IP Phone Guide for Cisco Unified Communications Manager 8.5(1) (SCCP and SIP)
Then...
Use the Join or DirTrfr softkeys.
Check with your system administrator to see if this feature is
available to you.
See Viewing or Removing Conference Participants, page
Then...
Highlight the call and press cBarge to complete the action.
See Using a Shared Line, page 33
See Viewing or Removing Conference Participants, page
Then...
2. Distribute the number to participants.
3. When you are ready to start the meeting, go off-hook to get a dial
tone, then press MeetMe.
4. Dial the Meet-Me conference number.
Participants can now join the conference by dialing in.
Note Participants hear a busy tone if they call the conference before the
initiator has joined. In this case, participants must call back.
Dial the Meet-Me conference number (provided by the conference
initiator).
Note You will hear a busy tone if you call the conference before the
initiator has joined. In this case, try your call again.
All participants must hang up.
The conference does not automatically end when the conference
initiator disconnects.
Basic Call Handling
for more information.
28.
28.
27