Rc3000-Sub-Opt-Fe Explanation; Rc3000-Sub-Opt-2E1 Explanation - Raisecom RC3000 PCM User Manual

7.13. RC3000-SUB-OPT-FE explanation

Optical line-board can communicate with main board and its initial value can be set
through DIP switches. There are 2 banks of 8-bit DIP switches and definitions ard as
follows:
Switch Definition
Optical
module
1-4
type
SW1
5 ALS
Auto
6
negotiation
7 100M/10M
Full/half
8
duplex
1-4E1
1-4
Loop back
SW2
Loop back
5
type
6-8 Reserved
Note: F stands for OFF and N stands for ON status. Network management has higher
privilege than DIP switches except optical module type and ALS function configuration.
All configuration information is available through Hyper Terminal. First bit to fifth bit of
SW1 are set in factory according to optical module type and other bits are all OFF.

7.14. RC3000-SUB-OPT-2E1 explanation

Optical line-board can communicate with main board and its initial value can be set
Value
FFFF
FFFN
FFNF
FFNN
FNFF
FNFN
FNNF
FNNN
NFFF
Other Other status will be regarded as S1 (0000)
F
N
F Enable auto negotiation function
N Disable auto negotiation function
Ethernet port rate is 100M (auto negotiation
F
Ethernet port rate is 10M (auto negotiation
N
Ethernet port works in full duplex mode (auto
F
Ethernet port works in half duplex mode (auto
N
F Relative E1 line works normally
N Relative E1 line is doing the loop back test
F
N
45
Raisecom Technology Co., Ltd
Explanation
S1
S2
S3
SS13
SS15
SS23
SS25
S1FC
M
Without ALS function
With ALS function
disable)
disable)
negotiation disable)
negotiation disable)
Local loop back
Remote loop back
Reserved