Id Set; Baud Rate Set; Line-Board Set - Raisecom RC3000 PCM User Manual

10.9.1. ID set

In system set menu press number key 1 to configure device ID:
DeviceID=2
Input Device ID(0-255):
The first row is device present ID and the second row is for user configuring a new ID.
If you do not input number but press ENTER key, the old ID will be effective. And if you
input a number and then press ENTER key, this number will be the device ID.
The range of device ID is 0-255 and 0 indicates to clear the ID, the invalid number will be
ignored. BackSpace key is available to change the input.

10.9.2. Baud Rate Set

In system set menu press number key 1 to configure Baud Rate:
Baud Rate=2(2400bps)
Baud Rate(1:300,2:2400,3:4800,4:9600):
The first row is device present Baud Rate and the second row is for user configuring a
new Baud rate.
If you do not input number but press ENTER key, the old Rate will still be effective. And if
you input a number and then press ENTER key, this configuration will be effective.
The range of Baud Rate is 0-4 and 0 indicates to clear the Baud Rate, the invalid number
will be ignored. BackSpace key is available to change the input.

10.9.3. Line-Board set

In system set menu press number key 1 to configure Line-Board, and at present there
are three ways to configure Line-Board:
a. Without CPU the prompt will be:
The line board is 2E1 Board, it can't be set.
System Set Command:1-9, Menu Display:M, Return:Q
b. With optical line-board, the menu will be:
1.Alarm Mask Set
2.Loopback Set
3.ALS Set
4.Ether Net Port Set
5.Ether Net Port Work Set
6.Transmit Band Width Set
7.Receive Band Width Set
8.Reset Ether Net
Optical Board
Set Command:1-8, Menu Display:M, Return:Q
Note: the explanation of each command is available in 10.9 Line Board Set menu
Raisecom Technology Co., Ltd
Command:
Command:
64