Note: system initialization will set all configurations in 0 status, and parts restore to
factory default value. All cross set will be cleared.
10.17.4.
Clear Cross Set
In operate menu press number key 4 to clear cross set:
Run this command,the device will format all cross data.
All data will be nil.
Run this command(Y/N):
Press Y to start initializing all cross connect and N to cancel.
10.17.5.
Save Set Info
In operate menu press number key 5 to save all information in RAM to EEPROM.
10.17.6.
Make Default Set
In operate menu press number key 6 to restore factory default value:
Run this command,the device will be first state from manufactory.
All saving data will be losed. The device will restart.
Run this command(Y/N):
All information in EEPROM will be invalid if you press Y key, and press N key will exist.
By default, except hardware version there is no information in EEPROM. So restore to
factory default value is same as delete all saved information.
10.17.7.
Clear Reset and Board-Change Flag
In operate menu press number key 7 to clear flag information of resetting device and
changing the board. And there is no prompt.
10.17.8.
Test Watchdog
In operate menu press number key 8 the check whether watchdog can reset CPU.
Normally watchdog program will restart CPU, and in abnormal status the system cannot
exist from closed-loop.
10.17.9.
Test EEPROM
In operate menu press number key 9 to test whether EEPROM can save data normally:
Normally there will be:
Can save data to EEPROM.
Abnormally there will be:
Raisecom Technology Co., Ltd
82