Powered On - Raisecom RC3000 PCM User Manual

offered, and when you need to transfer balanced interfaces to unbalanced ones
RC909-4E1 of Raisecom is available.
c. Optical interface:
SC connector is for optical interface. And if you are not sure of Rx & Tx direction,
please connect the connector before device powered on.
d. Connect network management interface:
When this device is connected with network management PC, connect cable to
LINK UP interface; and when you need network management cascade, connect
cable to LINK DOWN interface. Please connect to network management interface
before device powered on if you are not sure of common grounding.

8.3.3. Powered on:

a. Verify all the connections are normal (power supply and interfaces), and than
powered on.
b. Verify the self-check of the device is normal (PWR is ON and SYS is flicking).
Buzzer will buzz if there are alarms and MUTE botton can shutdown present
alarm sound.
c. You do not need to configure the device for point-to-point topology. Use
CONSOLE interface to configure the device when necessiry.
d. RC3000 will work normally if all connections are right.
Raisecom Technology Co., Ltd
48