Installing An Integrated Channel; Service Unit (Icsu) Module; Checking For Required Components - Avaya CMC1 Installation Manual

Circuit Pack Verification
1
Type change circuit-pack and press Enter.
2
Check the Code column to see if it says DSMAPD or MedPro.
.
change circuit-packs
01: TN754
02: TN758
03: TN2144
04: TN746
05
06: TN771
07: TN464
08: TN2140
09: TN767
10: TN799
3
To correct it, go to the entry just above the TN802B that says DSMAPD.
4
Type MEDPRO, and press Enter. Changing the one entry automatically changes the entry above
it. If it is in IP Trunk mode, you get the following error message:
MedPro type requires TN802 with application. Type MEDPRO on circuit-packs
form.
5
To complete the administration, refer to Administration for Network Connectivity for Avaya
Communication Manager.

Installing an Integrated Channel

Service Unit (ICSU) Module

The integrated channel service unit (ICSU) is a combination of a 120A3A CSU module integrated with a
DS1 circuit pack. A 700A DS1 loopback jack must be installed with this device.

Checking for required components

The integrated channel service unit (ICSU) package contains:
•
120A3A CSU module
NOTE:
Re-manufactured/repaired ICSU units and any manufactured after May 7, 2002 are
marked as "120A3A."
•
700A DS1 loopback jack
Installation, Upgrades and Additions for Avaya CMC1 Media Gateways
June 2004
Cabinet: 1
Slot Code Sf Mode Name
DIGITAL LINE
POOLED MODEM
ANALOG LINE
B ANALOG LINE
C MAINTENANCE/TEST
F DS1 INTERFACE
E&M TIE TRUNK
E DS1 INTERFACE
B CONTROL-LAN
'#' indicates circuit pack conflict.
Adding or Removing Hardware
Installing an Integrated Channel Service Unit (ICSU) Module
CIRCUIT PACKS
Carrier: A
Carrier Type: processor
Slot Code
11: MEDPRO
12: MEDPRO
13: TN802
14:
15:
16:
Page 1 of 5
Sf Mode Name
RESERVED-IP
RESERVED-IP
B MAPD BOARD
273