Add Isdn-Pri; North American; International; Add Packet Bus Support - Avaya CMC1 Installation Manual

Add ISDN—PRI

North American

1
Install a TN767E (or later) DS1 or a TN464GP DS1/E1 circuit pack for a signaling link and up to
23 ISDN — PRI Trunk Group members.
2
Install a Tone-Clock circuit pack to provide synchronization for the DS1 circuit pack.
If using a TN464GP, then packet bus support has not been added, requiring more than 8 PRI signaling
groups. See

Add Packet Bus Support

International

1
Install a TN464GP DS1/E1 circuit pack for the assignment of the 2 signaling channels and up to
30 ISDN — PRI Trunk Group members. Each E1 span provides 32 ports.
2
Install a Tone-Clock circuit pack to provide synchronization for the DS1/E1 circuit pack.
If using a TN464F, then packet bus support has not been added, requiring more than 8 PRI signaling
groups. See Add Packet Bus Support
Add Packet Bus Support
1
If packet bus support is not already installed, see
perform the steps.

Add Circuit Packs

1
Determine port assignment of circuit packs to be added.
2
Install the DS1 Interface circuit pack in the assigned carrier slot.
3
Install a Tone Detector circuit pack if required.

Install Cables

1
Install cables from the TN464F to the MDF as required.

Enter Added Translations

1
Administer the forms listed under "Integrated Services Digital Network — Primary Rate
Interface" in Administrator's Guide for Avaya Communication Manager.

Resolve Alarms

1
Examine the alarm log. Resolve any alarms that may exist using Maintenance for Avaya
DEFINITY Server CSI.
Installation, Upgrades and Additions for Avaya CMC1 Media Gateways
June 2004
on page 228 for adding circuit packs for packet bus support.
on page 228 for adding circuit packs for packet bus support.
Add Packet Bus Support
Adding or Removing Hardware
Add ISDN—PRI
on page 228 and
227