Table of Contents
Advertisement
Using Alternate Remote Codes
Using Alternate Component Keys on your Remote
The DVS5.1 will also respond to alternate component key codes. Allowing you to use an unused
TV, VCR, RCVR or one of the added AUX positions many remotes include.
Setting up the DVS5.1 to respond to alternate component codes is a two step process. You must
first program your universal remote control to behave as one of the alternate components. You must
then configure the DVS5.1 to respond to the alternate component codes.
Programming your remote to different components
The DVS5.1 will respond to eight different pre-programmed component codes. They are: Awia
DVD, Yamaha VCR, Hitachi Satellite, Sony TV, Go Video VCR, Nakamichi Receiver, Jerrold Cable
Box and a Symphonic TV. The following table shows the different component buttons and codes
used to program a few different universal remotes.
Make
Awia
Yamaha
Symphonic
Sony
Hitachi
Go Video
Jerrold
If your remote control's model matches one of the above, read your remote's user manual for in-
structions on programming your remote control. Then use the above device and manufacturer
codes to setup your remote.
If your remote is not included in the above list, or the manufacturer code given does not work, then
you will have to follow your remote controls instructions for programming one of the above compo-
nents and search for a proper match. See the next section. Or teach the DVS5.1 a new set of codes,
See: "Learning New Remote Codes" on page 10.
Configuring the DVS5.1 for an alternate component code
After your remote control has been programmed to act like one of the 8 built in code-sets, teaching
the DVS5.1 to use the new code set is simple.
One For
Device
Sony
DVD
015
VCR
040
TV
023
TV
001
SAT
N/A
VCR
N/A
CBL
001
Sanyo RCA
All
0641
N/A
350
0038
238
009
0171
104
189
0000
110
002
0819
N/A
084
0432
248
138
0476
303
046
8
Zenith
X10
N/A
N/A
025
022
520
202
708
015
N/A
N/A
139
013
552
062
Advertisement
Table of Contents
