Three Simple Steps To A Remote - Zektor CVS4 User Manual

Step 1: Put the CVS4 into the Setup Mode
1
Press and hold the Power Button for 4 secs.
The standby LED will blink wildly, and the
selection LEDs will start sequencing to the
right. (You'll know it when it happens!)
Step 2: Press the '1' button for Intelligent-IR™ learning
1
Once the '' button
is pressed...
Step 3: Teach the CVS4 its new IR codes
1
Press the following sequence of buttons on
your remote control:
POWER
1 2 3
Power 1 2 3 4 8 9 0
4 5 6
7 8 9
0
That's it! The CVS4 now operates with your
+ +
_ _
VOL CH
6 CVS4 Component Video Switch
2 3 4
2 3 4
...the standby LED will flash slower,
and all the other LEDs will turn off.
2 3 4
new remote control!

Three Simple Steps to a Remote!

The C VS4 features Zektor 's Exclusive I ntelligent-IR™, and with ver y
few exceptions can be setup to use any remote you can point at it!
Pick a remote, any remote!
•
Star t by pick ing the remote you'd like to use with the C VS4.
I f the remote you plan on using is not programmable (for
instance, from an old T V ), sk ip the nex t step.
•
I f you plan on using a universal remote, star t by setting it
up as a remote for a T V or VCR that you do not own. (For
instance if you don't own a S ony T V, setup your universal
remote to control a S ony T V.)
Step 1: Put the CVS4 into the Setup Mode
•
The C VS4 is placed into the setup mode by pressing and
holding the Power button for about 4 seconds.
Step 2: Select the Intelligent-IR™ Learn Mode
•
There are many options available in the setup mode, but for
now all we're interested in is the I ntelligent-IR™ lear ning
mode. This is selec ted by pressing the '' button.
•
Once the '' button is pressed, the standby LED will flash
slower and all the other LEDs will tur n off. The C VS4 is
now waiting for new IR codes to be sent from your remote
control.
Step 3: Teach the CVS4 your new remote control codes
•
On your remote control, press the following buttons, in the
following order :
Power 1 2 3 4 8 9 0
•
That 's it! The C VS4 will retur n to the state it was in before
setup, and will now wor k with your new remote!
The new control buttons on your remote are...
Power Toggles the C VS4's power.
1 - 4 S elec ts inputs  through 4.
8
Tur ns on the C VS4 (Discrete ON)
9
Tur ns off the C VS4 (Discrete OFF).
0
S equences through inputs.
Note: All remote control codes are saved in non-volatile
memor y and will not be lost during a power failure.
CVS4 Component Video Switch 7