Three Simple Steps To A Remote - Zektor HDS4.1 User Manual

Step 1: Put the HDS4.1 into the Setup Mode
ZEKT O R 1
Press and hold the Power Button for 4 secs.
The standby LED will blink wildly, and the
selection LEDs will start sequencing to the
right. (You'll know it when it happens!)
Step 2: Press the '1' button for Intelligent-IR™ learning
ZEKT O R
1
Once the '' button
is pressed...
Step 3: Teach the HDS4.1 its new IR codes
Z E K T O R
1
Press the following sequence of buttons on
POWER
your remote control:
1 2 3
4 5 6
Power 1 2 3 4 8 9
7 8 9
0
+ + That's it! The HDS4. now operates with
_ _
VOL CH
6 HDS4.1 Component Video Switch
2 3 4
2 3 4
...the standby LED will flash slower,
and all the other LEDs will turn off.
2 3 4
your new remote control!

Three Simple Steps to a Remote!

The HDS4. features Zektor 's Exclusive I ntelligent-IR™, and with ver y
few exceptions can be setup to use any remote you can point at it!
Pick a remote, any remote!
•
Star t by pick ing the remote you'd like to use with the
HDS4.. I f the remote you plan on using is not programma-
ble (for instance, from an old T V ), sk ip the nex t step.
•
I f you plan on using a universal remote, star t by setting it
up as a remote for a T V or VCR that you do not own. (For
instance if you don't own a S ony T V, setup your universal
remote to control a S ony T V.)
Step 1: Put the HDS4.1 into the Setup Mode
•
The HDS4. is placed into the setup mode by pressing and
holding the Power button for about 4 seconds.
Step 2: Select the Intelligent-IR™ Learn Mode
•
There are many options available in the setup mode, but for
now all we're interested in is the I ntelligent-IR™ lear ning
mode. This is selec ted by pressing the '' button.
•
Once the '' button is pressed, the standby LED will flash
slower and all the other LEDs will tur n off. The HDS4. is
now waiting for new IR codes to be sent from your remote
control.
Step 3: Teach the HDS4.1 your new remote control codes
•
On your remote control, press the following buttons, in the
following order :
Power 1 2 3 4 8 9
•
That 's it! The HDS4. will retur n to the state it was in before
setup, and will now wor k with your new remote!
The new control buttons on your remote are...
Power Toggles the HDS4.'s power.
1 - 4 S elec ts inputs  through 4.
8
Tur ns on the HDS4. (Discrete ON)
9
Tur ns off the HDS4. (Discrete OFF).
Note: All remote control codes are saved in non-volatile
memor y and will not be lost during a power failure.
HDS4.1 Component Video Switch