Adjusting The Front Panel Intensity - Zektor HDS4.1 User Manual

Step 1: Place the HDS4.1 into the Setup Mode
ZEKT O R 1
Press and hold the Power Button for 4 secs.
The standby LED will blink wildly, and the
selection LEDs will start sequencing to the
right.
Step 2: Select "Front Panel Intensity" option
ZEKT O R
1
After '4' is pressed, the standby LED con-
tinues to flash, and the front panel will
display the current intensity setting.
Step 3: Adjust front panel intensities
ZEKT O R
1
0 HDS4.1 Component Video Switch
2 3 4
2 3 4
2 3 4
Press to Brighten LEDs
Press to Dim LEDs
Selects BRIGHT level
Selects DIM level
Exit Setup Mode

Adjusting the Front Panel Intensity

The br ight and dim levels of the front panel lights of the HDS4. are
user adjustable, allowing the HDS4. to blend into a wide range of
lighting conditions.
To change the front panel intensities...
Step 1: Enter the Setup Mode
•
The HDS4. is placed into the setup mode by pressing and
holding the Power button for about 4 seconds.
Step 2: Select the Front Panel Intensity option
•
Press the '4' button to selec t "Front Panel I ntensit y " option.
•
The front panel selec tion LEDs now indicate the front panel
intensit y settings:
I f '' is lit, then the DIM level is being adjusted.
I f '2' is lit, then the BRIGHT level being adjusted.
'' and '4' are always lit.
Step 3: Adjust Front Panel Intensities
•
Use the '' and '2' buttons to switch bet ween the DIM and
BRIGHT settings.
•
Use the '' button to decrease the intensit y of the front
panel lights.
•
Use the '4' button to increase the intensit y of the front
panel lights.
•
You cannot make the DIM level br ighter than the BRIGHT
level, and you cannot make the BRIGHT level dimmer than
the DIM level.
•
Once the front panel intensities are acceptable, press the
Power button to save the new settings and exit the setup
mode.
Note: The new intensit y settings are saved in non-volatile
memor y and are not affec ted by a power failure.
HDS4.1 Component Video Switch