Gas Control - Cannon CANTERBURY FREESTANDING User Instructions

Advise the user in the
operation of the heater.
12
Position the four individually numbered logs in the following order on
the burner head as shown in figures 15 - 18. The male locating pins in
the burner head must engage with corresponding holes in the indi-
vidual logs.
a) Place log No.1 onto the 2 front left
pins on the burner head, ensuring that
the charring faces the front.
Refer figure 15.
b) Place log No.2 onto the 2 left
back pins. Refer figure 16.
c) Place log No.3 on single right
front pin, ensure fork locates over log
No. 2. Refer figure 17.
d) Place log No. 4 on single right
back pin, ensure left side of log rests
on depression in No. 3 log.
Refer figure 18.
13. Refit the inner glass, but do not
overtighten the screws.
14. Refit the front glass surround. En-
sure that the glass surround is re-
placed the correct side up. The
rearward sloping frame must be
at the top and the vertical edge
must be at the bottom. Refer figure
19.

Gas control

15. Gas control layout is as indicated in figure 20
Operate the heater on HIGH and LOW burner and all fan speeds.
The flame should be stable, no lifting from the burner, and the logs
should glow after approximately 15 minutes of operation on HIGH
burner.
15
16
17
18
19