Gas Control - Cannon FITZP User Instructions

Gas control

b) Place log No.2 onto the 2 left back pins. Refer figure 18.
18
c) Place log No.3 on single right front pin, ensure fork
locates over log No. 2. Refer figure 19.
19
d) Place log No. 4 on single right back pin, ensure left side
of log rests on depression in No. 3 log. Refer figure 20.
20
15. Refit the inner glass, but do not overtighten the screws.
16. Refit the front glass surround. Ensure that the glass surround is
replaced the correct side up.
17. Gas control layout is as indicated in figure 21.
Pressures for 'Burner full on' and 'Burner low flame' are
factory set, however if pressures need to be checked or
adjusted follow the procedures described below and on
the next two pages.
21
13