Standards - Cannon FITZPIB User Instructions

Standards

7. If removed the glass window must be put back onto the unit
prior to operating the heater.
8. Installation and repairs should be performed by a licensed
service person only, refer to back of brochure for service number.
9. For installation into a non-combustible fireplace, i.e.: masonry
or brick or into a mock fireplace, i.e. timber or plasterboard,
the chimney and base should be of sound construction and be
free from cracks and holes (to ensure that sufficient flue draught
can be generated).
NOTE: WHEN INSTALLING INTO A MOCK FIREPLACE A
MOCK FIREPLACE INSTALLATION KIT MUST BE USED.
10. The heater must be properly installed in a working chimney or
connected to a venting system. Operation of this heater, when
not connected into a working chimney or a properly installed
and maintained venting system can result in carbon monoxide
(CO) poisoning and possible death.
11. The appliance should be inspected prior to use, with regular
inspections (annually) to be made by a licensed service per-
son. It is important that circulating air passageways of the
appliance be kept clean, dirt and lint free, for a safe and
efficient operation of the heater.
12. On first lighting your heater a smell may occur due to it's new
condition. This is quite normal and will disappear after a few
hours use at the maximum control position.
Important:
WHEN THIS HEATER IS OPERATING, THE MESH GUARD IS HOT.
The mesh safety guard fitted to the heater conforms to AGA require-
ments.
For heaters fitted with the optional glass front it should be noted that
THE GLASS FRONT IS HOT.
For permanent protection of young children or the infirm a second-
ary guard should be placed around the heater. A secondary guard
is not provided with this heater and may be purchased by the
owner.
This appliance meets the following standards:
Standards Australia: AS 3100
AS 5601/AG 601
AS 4553/AG 103
5