Gas Connection; Log Installation - Cannon FITZFS-SDSEB-NG User Instructions

12

Gas connection

12. Connect incoming gas supply pipe to
of appliance. For inlet position see figure 15.
15

Log installation

13. The burner is contained
within the burner cham-
ber. .Refer figure 16.
14. Carefully unpack the log set. Logs are numbered as follows:
No 1 - Left front log
No 2 - Left back log
No 3 - Right front log
No 4 - Right back log
Position the four individually numbered logs in the following order on
the burner head as shown in figures 17-20. The male locating pins in
the burner head must engage with corresponding holes in the indi-
vidual logs.
a) Place log No.1 onto the 2 front left
pins on the burner head, ensuring that
the charring faces the front. Refer figure
17.
b) Place log No.2 onto the 2 left back
pins. Refer figure 18.
c) Place log No.3 on single right front
pin, ensure fork locates over log
No. 2. Refer figure 19.
1 /
16
17
18
19
" compression fitting at rear
2