Installing The System Into A Rack; Identifying The Sections Of The Rack Rails; Installing The Inner Rails - Supero SUPERSERVER 6017R-N3RF4+ User Manual

S S
UPER ERVER 6017R-N3RF4+/6017R-N3RFT+ User's Manual
2-4

Installing the System into a Rack

This section provides information on installing the 6017R-N3RF4+/6017R-N3RFT+
into a rack unit with the rack rails provided. If the system has already been mounted
into a rack, you can skip ahead to Sections 2-5 and 2-6. There are a variety of rack
units on the market, which may mean the assembly procedure will differ slightly.
You should also refer to the installation instructions that came with the rack unit
you are using.

Identifying the Sections of the Rack Rails

You should have received two rack rail assemblies in the rack mounting kit. Each
assembly consists of two sections: an inner fi xed chassis rail that secures directly
to the server chassis and an outer fi xed rack rail that secures directly to the rack
itself (see Figure 2-1). Two pairs of short brackets to be used on the front side of
the outer rails are also included.

Installing the Inner Rails

Both the left and right side inner rails have been pre-attached to the chassis. Pro-
ceed to the next step.
Figure 2-1. Identifying the Sections of the Rack Rails
Inner Rail
(left side rail shown)
Locking Tab Outer Rail
2-4