Adding Pci Cards - Supero SUPERSERVER 6017R-N3RF4+ User Manual

5-6

Adding PCI Cards

PCI Expansion Slots
Riser cards installed to the system allow you to add PCI expansion cards (see be-
low). The SC819TQ-R700WB can support the use of two standard size (full-height,
half-length) expansion cards and one low-profi le (4.1" length) expansion card (with
pre-installed riser cards).
PCI Card Installation
Before installing a PCI add-on card, make sure you power off the system fi rst. Begin
by removing the top chassis cover. Two riser cards should be pre-installed into the
system. Remove the latch from the expansion card slot at the rear of the chassis
then lift the riser card assembly from the chassis. Insert the PCI card into the riser
card slot, pushing down with your thumbs evenly on both sides of the card - note
that the add-on card attaches to the riser card with a single screw. After the card has
been installed, reinstall the riser card then reinsert the latch back into the expansion
card slot. Finish by replacing the chassis cover.
Riser Card
RSC-R1UW-2E16 (left side)
RSC-R1UW-E8R (right side)
# Expansion Card
1 Low-profi le (2.536"), 4.1" length
2 Full-height (4.2"), 10" length
Chapter 5: Advanced Serverboard Setup
PCI Slot/Card Confi gurations
Expansion Card Supported
1x PCI-E x16 and 1x PCI-E x8 cards (full-height, half-length)
1x low-profi le PCI-E x8 card (4.1" length)
1
PCI Card Locations
# Expansion Card
3 Full-height (4.2"), 6.6" length
5-11
2
3