Table of Contents
Advertisement
S
S
UPER
ERVER 6017R-N3RF4+/6017R-N3RFT+ User's Manual
Installing/Removing a Hard Drive
1. To remove a carrier, push the release button located beside the drive LEDs.
2. Swing the colored handle fully out and use it to pull the unit straight out (see
Figure 6-4).
Note: Your operating system must have RAID support to enable the hot-plug ca-
pability of the hard drives.
Release tab
Figure 6-4. Removing a Drive from the Server
Hard Drive Backplane
The hard drives plug into a backplane that provides power and drive ID. A RAID
controller can be used with the backplane to provide data security. The operating
system you use must have RAID support to enable the hot-swap capability of the
drives. The backplane is already preconfi gured, so there are no jumpers or switches
present on it.
6-6
Advertisement
Table of Contents
