Toshiba TOSVERT VF-A7 Instruction Manual page 64

Searching for a parameter and changing its setting
Follow the procedure below to search for parameters and change their settings.
Key operated
MON
ENT
ENT
OR
ENT
ENT
Parameter display
MON
MON
If you feel puzzled about what to do next during this operation, press the Monitor key
several times to return to the step  and follow the above steps all over again.
LED display
The operation frequency is displayed. (Make this setting
when the motor is out of operation.)(If the monitor display

mode setting parameter
frequency])
Press the MON key to call up the first basic parameter

 (Automatic acceleration/deceleration).
Select the user group parameter  by pressing the

or
Press the Enter key to enter the user parameter search

and change mode.
The inverter searches for and displays parameters the
settings of which are different from their respective
default settings. Press the Enter key or

parameters displayed. (Press the key to search for
parameters in reverse direction.)
Press the [MON] key to display the parameter setting

(set value).
Change the parameter setting by pressing

key.
Press the enter key to save the change. Then, the
parameter code and the set value are displayed

alternately.
Following the same steps as above, search for and
display other parameters you want to change, one by

() one, by pressing the
their settings.
 is displayed again after completion of a

search for all changed parameters.
To cancel the parameter search in process, press the
Monitor key. Press the Monitor key once during search
to return to parameter setting mode. Then, press the

Monitor key to return to status monitor mode or normal
monitor mode (operation frequency display mode).

D-6
Operation
is set at [Running

key.
or key, to check or change
key to switch
or