Toshiba TOSVERT VF-A7 Instruction Manual page 201

No. Option name
RS-232C
communication
converter cable
RS-485 communication
converter unit
(for communication with
multiple inverters)
Communication cable
Remote control panel
Application control units
Harmonic suppression
converter
Power regeneration
converter
Option should be used under the condition of 9600 bps or less ().
Function, purpose.
If this unit is used to connect the inverter and a personal computer and so on with each other, data communication can
be performed between the two besides easy adjustment of parameters, saving and writing data.
RJ45 connector
(Model: RS20035)
More than one inverter can be controlled with a personal computer and so on if this unit is
used for connection between inverters and personal computer.
Computer link: Since this unit makes it possible to connect inverters with higher-class
computer, FA computer, etc., a data communication network can be
constructed among multiple inverters.
Communication among inverters: For the purpose of proportional operation of multiple
<Outline drawings with dimensions>
(Model: RS4001Z)
Connection cable for connecting parameter writer, extension control panel,
RS-232C communication units, and RS-485 communication units.
Cable types: CAB0011 (1 m), CAB0013 (3 m), CAB0015 (5 m).
A frequency meter, frequency setup device, RUN/STOP (forward, reverse) switch
are built in this operation panel. (Model: CBVR-7B)
Applied control units of the AP series make various applied control possible if they
are used in combination with the inverter.
Proportional control panel (APP-2B)
Ratio setup panel (APH-7B)
Regulated power supply board (APV-2B)
Cushion starter panel (APC-2B)
Synchronizing control panel
(APS-2B1)
Synchronizing transmitter (DRR-2)
Remote control panel (APM-2B)
Higher harmonic suppressor unit improves input power-factor by suppressing
harmonic current.
Power regenerator unit protects the inverter from load sprung from frequent rapid
deceleration and negative torque.
For applicable models and particulars, inquire at our office.
I-8
<Outline drawings with dimensions>
5m
D-Sub 9pin connector
inverters, a frequency data communication network can
be constructed among multiple inverters.
(Model: RS4002Z)
Process control panel with built-in PI
controller (APJ-2B)
TG follower panel (APF-7B)
Current detection panel (APD-2B)
Torque control panel (APL-2B)
FV converter (APR-2B)
Loop controller (APU-2B)