Operating When Connected To A Pabx; Access Code; Activating/Deactivating Call Transfer - Ect (Explicit Call Transfer) - Gigaset C2 Operating Manual

Operating when connected to a PABX

i
Pay attention to the special features for SMS on PABX systems (page 70).

Access code

Precondition: If your phone is connected to a PABX you may have
– depending on the PABX – to enter an access code (outside line code) for external calls
when getting started the first time. See the operating instructions for your PABX. You
can enter a one to four-digit access code.
For incoming calls, the access code is automatically placed in front of the caller's phone
number in the display and in the call lists, and likewise when copied to the directory. The
saved phone number can then be dialled directly from the calls list (page 50)
v
s
Base Settings
s
Settings
~
OK
s
System settings
s
Access code
~
Í
s
Save entry
For manual dialling and entering directory, emergency and direct dial
i
numbers you must also enter the access code.
Activating/deactivating call transfer – ECT (Explicit Call Transfer)
Preconditions:
The service is supported by the exchange of your PABX.
◆
With some ISDN PABX systems, your two parties are not connected together, when
◆
you press the end call key during a call transfer (page 33). In this case you need to
activate this function. To do this, please refer to the operating instructions of your
PABX.
Operating when connected to a PABX
Open the menu.
Select the menu item and confirm.
OK
Select the menu item and confirm.
OK
Enter system PIN if required (page 91).
Select the menu item and confirm.
OK
Select the menu item and confirm.
OK
Enter access code and open the menu.
Confirm.
OK
129