Resetting Fast Access On The Answer Machine To Network Voice Mail; Operating When On The Move (Remote Operation) - Gigaset V300AM Setting Up

V300AM / USA EN / A31008-xxxxx-xxxx-x-6019 / answering_m.fm / 3.1.08
Setting recording quality
Set the quality you require for your record-
ings. The options are: Standard, High,
Excellent. If the quality is higher the
max. recording time is reduced.
¢ ¢
v Ð
Voice Mail
r
Select the recording quality.
Press the display key.
§Save§
Changing language for voice prompt
and pre-recorded announcement
v55O2
Enter the digits.
1
Set American-English.
§OK§
2
Set Canadian-French.
§OK§
I
Set Mexican-Spanish.
§OK§
Resetting fast access on the
answer machine to Network
Voice Mail
The integrated answer machine is factory-
set for fast access. However if you have set
the network mailbox for fast access
(page 25) you can reset this setting.
¢ ¢
v Ð
Voice Mail
/
Machine Network Mailb.
Select and press
a
Press and hold (idle status).
After you have selected the network mail-
box or the answer machine, press and
hold key 1. You will be connected
directly.
The setting for fast access applies to all
handsets.
¢
Record Quality
¢
Set Key 1 Answer
.
§OK§
Operating the answering machine
Operating when on the move
(remote operation)
You can check or activate the answer
machine from any other telephone (hotel,
pay phone etc).
Requirements:
u
You must set a system PIN to a 4-digit
number other than factory default of
0000 (page 35).
u
The phone you are using for remote
operation has tone dialing (DTMF),
such that you hear different tones
when you press the keys. Alternatively,
you can use a code transmitter (availa-
ble from your cell phone retailer).
Calling the answer machine and
playing back messages
~
Dial your own number.
9 ~
While you listen to your
announcement, press the
key and enter the system PIN.
You will be informed whether any new
messages have been recorded. The mes-
sages are then played back. You can now
operate the answer machine via the key-
pad or by voice prompts.
Operating the answer machine via the
keypad
The following keys are used for operation:
A
Go to the start of the previous
message.
B
Stop playback. Press 2 again to
resume.
3
Go to the next message.
:
Mark message as "new".
0
Delete current message.
Note:
After message playback, the call will be
terminated.
9
23