Displaying Call Charges - Gigaset C2 Operating Manual

Displaying call charges

You can display the charges if you have requested this from your network provider.
You can check the ongoing units /total charges and the charges of the last call made
(depending on setting, see page 75) on each Comfort handset. The total charges
includes the charges accrued by this handset. If you don't receive any rate information
from your network provider, the call duration is displayed.
Setting up the charge calculation
Ask your network provider if the call charges are transferred as a rate unit or as an
amount. Set the account type Units cent.off. or Costs cent.off. accordingly.
If you have selected Costs cent.off., but only units are transmitted by the network pro-
vider, after the call, it will automatically switch to Units cent.off..
By factory default, Units cent.off. is pre-set.
Setting the account type
v
s
Call Charges
s
Type of calcul.
either ...
s
Costs cent.off.
or ...
s
Units cent.off.
If you have also entered a factor (see "Entering the price per unit" section
below), the call charges are multiplied by this. You can also use a factor if
i
you want to charge higher call charges, otherwise switch off factor
(charges should be increased by a factor of 2);.
The No rate pre-set will display units.
Open the menu.
Select the menu item and confirm.
OK
Select the menu item and confirm.
OK
Set Costs cent.off.:
Select the menu item and confirm (
OK
Set Units cent.off.:
Select the menu item and confirm (
OK
Making cost-effective calls
‰
= activated).
‰
= activated).
73