Windows 2000 Dhcp Server - Avaya 4600 Series Administrator's Manual

Windows 2000 DHCP Server

This section describes the configuration of the DHCP server in Windows 2000
Verifying the Installation of the DHCP Server
Use the following procedure to verify whether the DHCP server is installed.
1
Select Start
2
Under Services and Applications in the Computer Management tree, you should find DHCP.
3
If DHCP is not installed, install the DHCP server; otherwise proceed directly to
Configuring a DHCP Scope
Creating and Configuring a DHCP Scope
Use the following procedure to create and configure a DHCP scope.
1
Select Start
2
In the console tree, click the DHCP server to which you wish to add the DHCP scope for the IP
telephones. Typically this will simply be the name of your DHCP server machine.
3
Select Action
Windows displays the New Scope Wizard to guide you through rest of the setup.
4
Click the Next button.
The Scope Name dialog box displays.
5
In the Name field, enter a name for the scope such as "DEFINITY IP Telephones," then enter a
brief comment in the Description field.
6
When finished, click the Next button.
The IP Address Range dialog box displays.
7
Define the range of IP addresses used by the IP telephones listed in
Information Before Installation - Per DHCP Server,
the first IP address available to the IP telephones. The End IP Address should be the last IP
address available to the IP telephones.
NOTE:
We recommend not mixing 4600 Series IP Telephones and PCs in the same scope.
8
Define the subnet mask in one of two ways:
•
The number of bits of an IP address to use for the network/subnet IDs.
•
The subnet mask IP address.
Enter only one of these values and when finished, click the Next button.
The Add Exclusions dialog box displays.
4600 Series IP Telephone Release 2.1 LAN Administrator's Guide
July 2004
Program Administrative Tools
on page 49 for instructions on server configuration.
Programs Administrative Tools
New Scope from the menu.
Server Administration
®
.
Computer Management.
DHCP.
Table 2, Required Network
on page 41. The Start IP Address should be
DHCP
Creating and
49