Windows Nt 4.0 Dhcp Server - Avaya 4600 Series Administrator's Manual

Windows NT 4.0 DHCP Server

This section contains details on how to verify and configure the DHCP server included in the
®
Windows NT
Use Verifying the Installation of the DHCP Server
If it is not, install the DHCP server. If it is installed, go to the section
the following section.
Verifying the Installation of the DHCP Server
Use the following procedure to verify whether the DHCP server is installed.
1
Select Start
2
Double-click the Network icon.
3
Verify that Microsoft DHCP Server is listed as one of the Network Services on the Services tab.
4
If it is listed, go to the section
server.
Initial Configuration
The Windows NT
DHCP scope is essentially a grouping of IP devices (in this case IP telephones) running the DHCP client
service in a subnet. The scope is used to define parameters for each subnet. Each scope has the following
properties:
•
A unique subnet mask used to determine the subnet related to a given IP address.
•
A scope name assigned by the administrator when the scope is created.
•
Lease duration values to be assigned to DHCP clients with dynamic addresses.
In addition, the DHCP server can assign configuration parameters to a client, and these can be specified
for each individual DHCP scope.
Setting up the Windows NT
1
Creating a DHCP scope for the IP Telephones.
2
Editing custom options.
3
Adding the DHCP options.
4
Activating the new scope.
Each step is detailed in the next four sub-sections.
4600 Series IP Telephone Release 2.1 LAN Administrator's Guide
July 2004
4.0 server operating system.
Settings Control Panel.
Initial Configuration
®
4.0 DHCP server configuration involves setting up a scope for the IP telephone. A
®
4.0 DHCP server requires the following steps:
below to verify whether the DHCP server is installed.
Initial Configuration
below. If it is not listed, then install the DHCP
Server Administration
DHCP
on page 45 and
45