Accessing Avaya Iw - Avaya G250 Administration

Accessing the Avaya G250/G350 Media Gateway
To access the G250/G350 CLI via telnet through a dialup connection from a remote location via
the S8300:
1. Connect a USB modem to either of the two USB ports on the Avaya S8300 Media Server. It
is recommended to use a Multitech MultiModem USB, MT5634ZBA-USB-V92.
2. Use the Avaya Maintenance Web Interface (MWI) to configure the USB port on the S8300
for modem use. For instructions, see Installation and Upgrades for the Avaya G250 Media
Gateway, 03-300434 or Installation and Upgrades for the Avaya G350 Media Gateway,
03-300394.
3. From a remote computer, create a dialup network connection to the S8300. Use the TCP/IP
and PPP protocols to create the connection.
4. Open any standard telnet program on the remote computer.
5. Enter the command telnet, followed by the IP address of the S8300 USB port to which
the modem is connected.
6. Enter the command telnet, followed by the PMI of the G250/G350.

Accessing Avaya IW

The Avaya Installation Wizard (Avaya IW) is a web-based installation wizard that is used with
the Avaya G250/G350 Media Gateway to perform initial configuration tasks and to upgrade
software and firmware. The Avaya IW is designed for use with systems that include an S8300
Media Server, operating in either ICC or LSP mode. See
(MGC) on page 60.
Specifically, you can perform the following tasks with the Avaya IW:
Configure PMI information — see
●
page 58
Configure SNMP information — see
●
Configure Ethernet interfaces — see
●
Configure primary and secondary Media Gateway Controllers — see
●
Controller (MGC)
Install license and password files
●
Install software and firmware upgrades — see
●
page 73
Enable and configure the USB ports of the S8300 for modem use
●
Enable the G250/G350 for modem use — see
●
use on page 125
Configure G250/G350 telephony and trunk parameters
●
38 Administration for the Avaya G250 and Avaya G350 Media Gateways
Configuring the Primary Management Interface (PMI)
Configuring SNMP
Configuring Ethernet ports
on page 60
The Media Gateway Controller
on page 203
on page 91
Software and firmware upgrades
Configuring the G250 and G350 for modem
on
The Media Gateway
on