Gathering Provisioning Data From Pim - Avaya G250 Administration

Configuring Standard Local Survivability (SLS) on the G250

Gathering provisioning data from PIM

Before enabling SLS, you must gather provisioning data from PIM and deliver it to the G250.
Run PIM's Device Profile Wizard to perform this task. The Device Profile Wizard gathers a
subset of the Communication Manager translations (dial plan analysis and destination routing
instructions) and delivers them to the G250. If PIM is not available, this translation subset (the
SLS data set) can be created manually, using the procedure described in
the SLS data through the CLI
PIM must be installed on and launched from the Avaya Network Management Console. For
information about PIM, see
From PIM's Device Profile Wizard:
1. Use the Add ARS Dial String page
in SLS.
Figure 6: Add ARS Dial String page (PIM)
Dialed String - Maximum 18 characters: only 0-9, '*' and 'X' or 'x' as a pre-string or
●
mid-string replacement. 'X' cannot be at the end of a dialed string.
Total Length is the length of the dialed string (up to 28 digits).
●
Call Type can be any of these values:
●
emer (emergency call)
●
fnpa (10-digit NANP call)
●
hnpa (7-digit NANP call)
●
intl (public-network international number call)
●
84 Administration for the Avaya G250 and Avaya G350 Media Gateways
on page 88.
Accessing PIM on page 41.
(Figure 6) to administer an Automatic Route Selection
Manually configuring