Table of Contents
Advertisement
• Connect Manually – After you select this option, go to the Status screen and
click "Connect." The router will connect to the ISP. To stop the connection,
click "disconnect."
TCP MSS Option: This enables the configuration of the maximum segment size
(MSS) for transient packets that traverse a router, specifically TCP segments in the
SYn bit set when PPPoe is being used in the network. Specify the MSS range
from 100 to 1452 bytes, or use the default value of 0 bytes.
Get IP Address: Choose "Static" or "dynamic IP Address." If "Static IP" is
selected, set the IP address, subnet mask and gateway obtained from your ISP.
Static IP Address: enter the IP address assigned by your ISP.
IP Subnet Mask: enter the subnet mask assigned by your ISP.
Gateway: enter the gateway assigned by your ISP.
NAT: network Address Translation (nAT) is an Internet standard that enables a
local-area network (lAn) to use one set of IP addresses for internal traffic and
a second set of addresses for external traffic. When nAT is enabled, the router
will help to make all the necessary IP address translations in order for the PC
connected to the router to access the Internet.
Default Route: When this is enabled, all the packets for destinations not known
by the router's routing table are sent to the default route. by default, it is enabled.
TCP MTU Option: The Maximum Transmission Unit (MTU) is the maximum size
of each packet in any transmission within the network. Specify the MTU range
from 100 to 1500 bytes, or use the default value of 0 bytes.
Dynamic Route: dynamic routing allows routing tables in routers to change
as the possible routes change. This router supports RIP1, RIP2-b and RIP2-M
protocols for dynamic routing. After the RIP protocol is selected, choose the RIP
direction from among "none," "both," "In only" or "oUT only."
Multicast: To specify the method of transmitting data simultaneously to many
receivers, select "IGMP v1" or "IGMP v2" as the multicast protocol. or, select
"disabled" to disable the function.
MAC Spoofing: Your ISP service requires identification of the MAC address of
the devices. You can enable the MAC Spoofing function and enter the valid
MAC address, allowing you to then change the MAC address of the router in
order to access the Internet service.
LAN
ROUTER LOCAL IP
IP Address: enter the IP address of the AdSl router for local access to the
router's Web page. by default, the IP address is 192.168.2.1.
IP Subnet Mask: enter the subnet mask of the AdSl router. by default, the
subnet mask is 255.255.255.0.
524360_524377_01_man.indd 17
Web MAnAGeMenT
17
12/18/08 2:23:48 PM
Advertisement
Table of Contents
