Hardware; Component Descriptions - Intellinet 524360 (Annex A) User Manual

2 hArDwAre

Component DesCriptions

Front Panel
As listed below, the leds indicate the current status of the router.
LED
PWR (green)
WlAn (yellow)
WPS (Yellow)
AdSl (green)
lAn (lnK/ACT) on
Ports 1-4 (green) off
Rear Panel
Antenna Connectors: The
reverse SMA connectors
allow easy connection
to external antennas.
Reset button: This can be used to reset the router or to restore the factory default
settings. Press the button (using a pencil tip can help) for less than five seconds
to re-boot the router and save any configurations that have been set up.
If problems persist after a simple re-boot — or if you've forgotten your password —
hold the button in for longer than five seconds to reset the router to its factory
default settings. NOTE: The factory default settings will replace any others that
have been configured.
Power outlet: The included 12 V DC power adapter is connected here.
WPS button: Wi-Fi Protected Setup (WPS) is the simplest way to build a connection
between wireless network clients and this router. Press this button and enable the
WPS function of the wireless clients; the router and clients will automatically
configure the security key and connect directly. NOTE: The router will wait for
WPS requests from wireless clients for 2 minutes after the WPS button is pressed.
LAN ports: The four local area network (lAn) ports are for connections to PCs,
lAns, printers, servers, hubs and so forth.
ADSL: The included RJ- 1 1 phone line connects this to an AdSl/phone network.
6
HARdWARe
524360_524377_01_man.indd 6
Mode Status
on Ready for operation.
off The wireless lAn is disabled.
blinking Wireless traffic is being transmitted/received.
off WPS function is disabled.
blinking WPS function is enabled.
on Successful connection to an AdSl dSlAn.
blinking no connection.
The lAn cable is connected to the router.
no network connection.
blinking network traffic is being transmitted/received.
12/18/08 2:23:40 PM