Lan - Intellinet 523455 User Manual

Get IP Address: Choose "Static" or "dynamic IP Address." If "Static IP" is
selected, set the IP address, subnet mask and gateway obtained from your ISP.
Static IP Address: enter the IP address assigned by your ISP.
IP Subnet Mask: enter the subnet mask assigned by your ISP.
Gateway: enter the gateway assigned by your ISP.
NAT: network Address Translation (nAT) is an Internet standard that enables a
local-area network (lAn) to use one set of IP addresses for internal traffic and
a second set of addresses for external traffic. When nAT is enabled, the router
will help to make all the necessary IP address translations in order for the PC
connected to the router to access the Internet.
Default Route: When this is enabled, all the packets for destinations not known
by the router's routing table are sent to the default route. by default, it is enabled.
TCP MTU Option: The Maximum Transmission Unit (MTU) is the maximum size
of each packet in any transmission within the network. Specify the MTU range
from 100 to 1500 bytes, or 0 bytes as the default value.
Dynamic Route: dynamic routing allows routing tables in routers to change
as the possible routes change. This router supports RIP1, RIP2-b and RIP2-M
protocols for dynamic routing. After the RIP protocol is selected, choose the RIP
direction from among "none," "both," "In only" or "oUT only."
Multicast: To specify the method of transmitting data simultaneously to many
receivers, select "IGMP v1" or "IGMP v2" as the multicast protocol. or, select
"disabled" to disable the function.

LAN

1
Web MAnAGeMenT ConFIGURATIon