Ais Range - Standard Horizon MATRIX GX2100 Owner's Manual

15.7.1 Transmitting and Individual call to a AIS Ship
It is possible for the GX2000 or GX2100 to transmit a DSC Individual call to a
received AIS target by the procedure below:
1. Press the one of the soft keys momentarily, then
press the [ CALL ] soft key.
2. Rotate the CHANNEL knob to select the operating
channel you want to communicate on and press the
CHANNEL knob. If the channel you want is not
shown, press the [ MANUAL ] soft key, then rotate
the CHANNEL knob to select the operating chan-
nel you want to communicate on, then press the
CHANNEL knob.
3. To transmit a Individual DSC call to the select AIS
ship, press the CHANNEL knob again.
After the GX2000 (when connected to an external
AIS) or GX2100 transmits, the radio waits for the
DSC radio on the AIS ship to transmit an reply, at
which time the radio will ring like a telephone. Pick
up the mic and press the PTT and hail the AIS ves-
sel.
4. Press the [ QUIT ] key to return to AIS screen.
5. Press the [ AIS ] key to return to radio screen.

15.8 AIS RANGE

You may change the display range of the AIS screen.
Press the one of the soft key momentarily, then press
the [ RANGE ] key to display the range selection
screen. Rotate the CHANNEL knob to select the
desired range and press the CHANNEL knob to save the
new range.
You may change the display range unit of the AIS screen, refer to sec-
tion "12.8 UNIT OF MEASURE".
GX2000/GX2100
NOTE
Page 107