Selecting The Display Range; Selecting The Arrival Range; Routing Operation - Standard Horizon HX890E Owner's Manual
Class-h dsc gps transceiver
Hide thumbs
Also See for HX890E:
- Owner's manual (116 pages) ,
- Firmware update instruction manual (5 pages)
Table of Contents
Advertisement
11.1.3 Selecting the Display Range
Use this menu item to set the range on the compass display.
Press and hold
key
1. Press the [CH▼]/[CH▲] key to select the desired range.
(Unit of measure depends on the settings in the GPS
SETUP menu. For details, refer to "16.8 UNITS OF
MEASURE". )
2. Press the [ENTER] soft key to store the selected setting.
3. Press the [CLR] key to return to radio operation.
11.1.4 Selecting the Arrival Range
This menu item sets the range within which the HX890 will signal arrival at the
destination.
Press and hold
key
1. Press the [CH▼]/[CH▲] key to select the desired range.
(Unit of measure depends on the settings in the GPS
SETUP menu.)
2. Press the [ENTER] soft key to store the selected setting.
3. Press the [CLR] key to return to radio operation.
11.2 ROUTING OPERATION
The HX890 allows setting 1 to 30 waypoints to create a route.
Current
position
WAYPOINT SETUP
(
/
key)
WAYPOINT SETUP
(
/
key)
Via3
Via2
Via1
r
outing to a
SELECT
DISPLAY RANGE
(
(
key)
SELECT
ARRIVAL RANGE
(
(
key)
W
ayPoint
/
key)
(
WAYPOINT SETUP
DISPLAY RANGE
AUTO
10nm
25nm
BACK
/
key)
(
WAYPOINT SETUP
ARRIVAL RANGE
0.05nm
0.1nm
0.2nm
0.5nm
BACK
Via29
Via30
WPT
SELECT
key)
2nm
5nm
ENTER
SELECT
key)
1nm
ENTER
67
Advertisement
Table of Contents
