Position Report; Setting Up A Dsc Position Report Ringer; Transmitting A Dsc Position Report Call - Standard Horizon MATRIX GX2100 Owner's Manual

11.9 POSITION REPORT

The feature is similar to Position Request, however instead of requesting a
position of another vessel this function allows you to send your position to
another vessel. Your vessel must have an operating GPS receiver connected
for the GX2000/GX2100 to send the position.
To transmit a Position Report Call, a GPS must be connected to the
radio and the GX2000 / GX2100 Individual directory must be programmed
with stations you wish to send your position to. To setup this directory
refer to section "11.5.1 Setting up the Individual / Position Call Direc-
tory."
11.9.1 Setting up a Position Report Ringer
The GX2000/GX2100 has the capability to turn off the Position Report ringer.
1. Press and hold down the [ CALL ( MENU )] key
until "Setup Menu" appears.
2. Rotate the CHANNEL knob to select "DSC
SETUP" menu.
3. Press the [ SELECT ] soft key, then select "DSC
BEEP" with the CHANNEL knob.
4. Press the [ SELECT ] soft key, then select "POS
Report" with the CHANNEL knob.
5. Press the [ ENT ] soft key, then select "Off" with
the CHANNEL knob.
6. Press the [ ENT ] soft key to store the selected set-
ting.
7. Press the [ QUIT ] soft key several times to return to
radio operation.
To re-enable the ringer tone, repeat the above procedure, rotating the CHAN-
NEL knob to select "On" in step "5" above.

11.9.2 Transmitting a DSC Position Report Call

Pre-Programmed Calling
1. Press the [ CALL ( MENU )] key. The "DSC
Menu" will appear.
2. Rotate the CHANNEL knob to select "POS RE-
PORT". (To cancel, press the [ QUIT ] soft key.)
3. Press the [ SELECT ] soft key.
4. Rotate the CHANNEL knob to select the name in
GX2000/GX2100
NOTE
Page 71