Time Setting; Factory Default - Strong SRT 6500 User Manual

PART 1 English
l

8.2.5 Time Setting

Press OK on 'Time Setting' in the Setup Menu. The following window will appear. Set the Local Time, Sleep Time, Timer Status and Program
the Timer.
Use CH p/q to move up and down the list
n
Use Vol t/u to change the setting
n
Displayed automatically and depends from channel number
Channel name:
Start time: Enter start time in format dd/mm/yyyy - day – hh:mm
Duration: Enter duration in hh:mm format
NOTE: Timer also can be programmed from EPG. See "Program Guide" chapter of this manual.
Press OK to store settings and go back to the previous mode
n

8.2.6 Factory Default

Press OK on 'Factory Set' in the Setup Menu. Confirm whether you wish to go back to the factory default settings.
This function will return all settings of the receiver to factory default. All your channels, favourite lists and settings will be cleared from
the memory.
Local Time: If you want to correct time and date then enter in format
dd/mm/yyyy - day – hh:mm
Sleep Time: 0 ~ 180 min. Receiver will be turned off after selected
time interval
Timer: Select timer number
Status: Disabled/Enabled. If Enabled – receiver will be turned on
within selected channels at defined "start time" and turned
off after "duration" interval
Channel type: TV/Radio
Channel number: Enter channel number. If you use multi satellite installation
– make sure to enter channel number in
"All satellites" mode
17