Strong SRT 6500 User Manual page 14

PART 1 English
l
8.2.2.1 DiSEqC 1.2 positioner setup
Mounting of the antenna on DiSEqC 1.2 positioner is complicated job. In order to get the best performance of the system it should be installed
by a professional.
In "Antenna Setup" menu set Positioner to "DiSEqC 1.2" and press OK button to enter to "Antenna position" menu.
Use CH p/q to move up and down in the list
n
Use Vol t/u to change the setting
n
Function: Set west limit / Set east limit – select it and press OK if you want to store current position of the dish as west / east limit;
Disable limit / Enable limit – select and press OK to disable / enable limits;
Recalculate – select and press OK to recalculate positions of all satellites based on adjustment for current satellite;
Nudge west / Nudge east – select and press OK for fine adjustment of the dish position;
Nudge tilt up / Nudge tilt down – use this command if your positioner support adjustment of elevation
Antenna status: Show you current status of the antenna (stopped, moving to East/West)
Signal Quality: Show quality of signal for selected reference transponder. Adjust antenna position in order to get maximum level of the
Signal Quality
Press EXIT to go back to the previous mode
n
Satellite: Select satellite position of which you would like
to setup
Transponder: Select reference transponder which should be used
for signal quality indication
When this item is highlighted press Vol t/u to
Move:
move dish in East/West direction accordingly
Save position: Highlight this item and press OK to store current
position of the dish for selected satellite.
The
is stored
Reference position: Highlight this item and press OK if you need to turn
dish to reference position (0 degree position).
¸
symbol shown near menu item once position
13