Starting Up For The First Time - Strong SRT 6500 User Manual

7.0 Starting up for the first time
Ensure that your satellite receiver is correctly connected to your television and dish, and that your satellite signal is of good quality. Check if all
connections are done in correct way. If you are not sure about this then ask your local Strong dealer to check your installation or satellite signal.
Once you start the receiver for the first time a country selection dialog will be displayed. Select your country from the list using Vol t/u buttons.
If your country is not in the list select "Other".
After selection of country a specific settings for selected country will be loaded.
For each country we have pre-loaded most popular channels.
If your antenna is primed to satellite Astra at 19E then you will get picture and sound on your TV.
If your antenna is pointed to other satellite then you will get on TV screen message "Invalid or no signal".
In this case do following steps:
Press OK button on your remote control. Channel list will be displayed
n
Press EXIT button. This will move focus to the field with name of satellite
n
Using Vol t/u buttons select satellite where your antenna is pointed and press OK
n
Focus will be moved back to channel list. Select channel of your choice and press OK button to confirm
n
It can be the case that satellite, where your antenna is pointed, is not in the list of pre-installed. Then you have to proceed with installation as
described below in "8.2 Setup menu". See "8.2.2 Antenna setup" and "8.2.3 Channel search".
10
PART 1 English
l