Direct Monitoring Through Audio Kontrol 1 - Native Instruments AUDIO KONTROL 1 Operation Manual

Direct Monitoring through AUDIO KONTROL 1

AUDIO KONTROL 1 provides you with its own monitoring facilities. This solution
has some advantages:
►
You can control it directly on the hardware.
►
The monitor signal is not affected by any potential latency issue.
To activate AUDIO KONTROL 1's hardware monitoring, follow these steps:
►
Engage the Monitor On/Off Switch on the hardware's front panel. On the hardware
top panel, one of the two monitoring LEDs (or both) will light up, depending on
your settings in the Mapping Application (see below).
►
Engage the Monitor Mono/Stereo Switch next to it, so that you can hear the voice
on both output channels.
►
In the Mapping Application you can select to which output the input signal is
monitored. Open the main menu's Monitoring entry: If the singer wants to hear
her (his) voice in the headphones, select 1/2 and 3/4. If the singer does not want
to hear her (his) voice, select 1/2, so that the voice only goes to your monitoring
speakers.
►
At any time, you can adjust the Monitor Level Knob to control the mix between
the music track coming from the computer and the voice coming directly from
Input 1.
AUDIO KONTROL 1 – 54