Text Messages To A Pabx - Gigaset CX150 isdn Instructions Manual

SMS (text messages)
Callback begins at once.
To a PABX: The access code (outside line code) is automatically put before
i
the phone number (page 86).
Adding a text message sender's telephone number to the directory
Precondition: You have opened the incoming message list and selected a message
(page 41).
MENU
s
Copy to dir.
OK
~
MENU
Save Text
a
The number of the text message recipient must be stored in the directory
i
together with its area code (prefix) so that it can also be used for sending
text messages.
Text messages
You can only receive a text message when the Calling Line Identification is
forwarded to the extension of the PABX (CLIP).
The CLIP of the phone number of the SMS centre is evaluated in your telephone.
If your phone is connected to a PABX, you may have to prefix the number of the SMS
centre with an access code (this depends on your PABX). You can store the access code
in your base (page 86).
If in doubt, you can test your PABX by sending a text message to your own number and
putting the access code before the number of the SMS centre. If you do not receive the
message, send another one, this time without the access code.
When you send messages, your sender number may be sent without your extension
number. The recipient cannot reply to you directly in this case.
44
Press the display key to open the menu.
Select the menu item and confirm.
OK
Confirm the telephone number.
Enter a name (up to 16 characters) (for inputting text
see page 96).
Press the display key to open the menu.
Confirm. The entry is stored.
OK
Long press (back to idle status).
to a PABX